wireguard-docs VS wireguard-vyatta-ubnt

I can’t find info about this in the quickstart guide. Are these the docs you’re talking about?

I think the official documentation is clear enough on the settings, and I don’t think the project can necessarily be blamed for others misinterpreting it. True, the AllowedIPs label can lead to some confusion for those who don’t read the docs. I think of it as those destination IPs that can be reached through the peer, and those source IPs that are accepted from the peer. See also this site: https://docs.sweeting.me/s/wireguard

You prolly should give a /32 on your interface ips. Here is this as well https://github.com/pirate/wireguard-docs. I don't understand exactly what you are trying to do, but if you are trying to pass traffic anywhere you need to enable packet forwarding at the Kernal level.

By the way, look at https://github.com/pirate/wireguard-docs

Thanks for the reply. I'm not sure which missing lines you're referring to though? According to this documentation, PostUp is used to run a command after the interface is initialised (same for PostDown, which apparently runs a command after the interface is deleted), but I'm not sure what commands exactly I'd need to run PostUp or PostDown for?

Find more example commands for inspecting the interface at https://github.com/pirate/wireguard-docs#inspect.

Joining serverless environments like AWS Lambda to a mesh network has traditionally been difficult because you can't directly access the network interfaces on the hosts that run your functions. The NetBird netstack mode addresses this by providing a simulated TUN device and a SOCKS5 proxy that targets that device. This allows your Lambda function to access other services in your NetBird network via the proxy.

NetBird simplifies Kubernetes access with its zero-configuration approach, leveraging WireGuard's simplicity and strength. It seamlessly integrates with various tools, offering transparency and high reliability as an open source solution.

WireGaurd

As for remote access, you will need another computer to install tailscale or wireguard vpn to access your local devices https://www.youtube.com/watch?v=AkKz7Vza1rw and the official docs for up to date advice https://www.wireguard.com/ this doesn't require much to run, you can use any old family computer or some old quad core 2nd-4th gen intel desktop for 30 bucks off facebook marketplace. You can also use that same computer to run klipper if you install proxmox and have two separate linux virtual machines.

Um modo mais avançado de se proteger é utilizando protocolos de VPN mais modernos, como o WireGuard. Muitos provedores de VPN oferecem suporte a este protocolo, que além de muito simples de usar e além do mais é open source.

here u find out how wireguard works https://www.wireguard.com/

WireGuard is a VPN protocol developed several years ago which is exremely fast, lightweight, and uses state-of-the art cryptography. Its performance blows legacy VPN's out of the water.

Try vanilla. It solved all my problems bar none.